Resetter Canon ip1900 Download– Owner Printer Canon IP Series would be familiar with this one issue. I often encounter this problem does not want to create a printer crash when printing in a customer wait, which again would reprint very annoying when working for even crashed …There software, this one is wrong
Software Reset Canon IP1900 – iP1980 is software that can be an alternative to reset printer Canon iP1980 / iP1900 canon. This software can repair the damage when the printer is a Canon iP1900 Ink Absorber.
The message is full now, and you will print, the printer lights blinking. This software is software for iP1800 printer reset or the previous type, but with a bit of care and patience, this software can also be used to reset the iP1900 printer.
How to use this software is as follows:
- First, we have to reset your canon printer manually
- Turn on the printer Canon IP1800
- Disconnect the power cable on your printer (the printer condition flame)
- By the time the printer is off, press the power button (Do not removable, press and hold) while reinstalling the printer power cable on the loose.
- The power button is still held down, and then you press the Resume button two times
- If it releases the power button before
- Then automatically canon IP1900 printer will be reinstalled by the computer wait until the installation is complete
- After the installation is complete, you try to see in the Start – Printers and Faxes then Canon IP1900 printer driver you grow is Canon IP1900 Copy 1
- Now try to test for reprint the printer you can be reused
Proceed to the second step
Second, we must reset using the reset canon iP1900 software that disease The Ink Absorber Full no recurrence is how:
- First Download Software Reset Canon iP1980 or Reset Canon IP1900 | General Tool below
- General Tool Open the downloaded
- The printer then you will be detected as “IP1800ASA” ga problem leave it
- Check the “Cleaning” and “EPROM Clear” and then press “Test pattern1” wait until a paper print test results and then “Test Pattern2,” wait until a paper print test results, and then “Test Pattern3,” and press “Play” and “Platen.”
- Close the software reset canon IP1900
- If you have, press the power button to turn off the printer and turn it on again.
- It’S Done
- Try a test for reprint. Hopefully, you will return to a normal printer
- If you do not succeed, then try again. There may be errors. Please do not give up because I have tried and succeeded
- No other software is better than General Tool software, but this software can only be used for printer versions under iP1980 IP1800 or IP1900, i.e., IP 1700, IP1100, and IP1900 software not yet to be used. Software Resetter this name is IPtool.